@article{Simone}2019,

title = {Effect of binder and load solubility properties on HPMC granules produced by wet granulation process},

author = {Veronica {De Simone} and Annalisa Dalmoro and Gaetano Lamberti and Diego Caccavo and Matteo D'Amore and Anna Angela Barba},

url = {https://www.sciencedirect.com/science/article/pii/S1773224718311043},

doi = {10.1016/j.jddst.2018.12.030},

year  = {2019},

date = {2019-02-01},

journal = {Journal of Drug Delivery Science and Technology},

volume = {49},

pages = {513-520},

abstract = {Hydroxypropyl methylcellulose (HPMC) is one of the most important hydrophilic ingredients used in hydrogel matrices preparation (tablets or granules). In this work, HPMC was used to produce granules loaded with hydrophilic and hydrophobic active molecules to investigate their possible use as release dosage forms for pharmaceutical and nutraceutical applications. Unloaded and vitamins loaded HPMC granules were produced by wet granulation to investigate the effect of molecule solubility and granulation liquid type, on physical, mechanical and release properties. Water-soluble vitamin B12 and water-insoluble vitamin D2 were used as model molecules. Due to their different solubility, two granulation liquid phases were also used: distilled water for granules with B12, and ethanol-water for granules with D2. Results showed that use of ethanol in the liquid phase reduces the granulation yield and produces granules having a less defined shape, a smaller mean size, a less hard structure and a worse flowability. Moreover, ethanol slightly enhances the polymer erosion rate. Results also emphasized that the vitamins solubility does not affect either the physical and the mechanical properties of the produced granules. However, it plays a significant relevant role on the molecule release mechanism, being B12 and D2 were released by diffusion and erosion mechanism, respectively.},

keywords = {Granulation, HPMC},

pubstate = {published},

tppubtype = {article}

}

@article{Simone}2018b,

title = {Wet-granulation process: phenomenological analysis and process parameters optimization},

author = {Veronica {De Simone} and Diego Caccavo and Gaetano Lamberti and Matteo D'Amore and Anna Angela Barba},

url = {https://www.sciencedirect.com/science/article/pii/S0032591018307800},

doi = {10.1016/j.powtec.2018.09.053},

year  = {2018},

date = {2018-12-01},

journal = {Powder Technology},

volume = {340},

pages = {411-419},

abstract = {Wet granulation is a size-enlargement process applied in many industrial fields, such as pharmaceutical, nutraceutical, zootecnichal, to improve flowability and compressibility properties of powders. In this work analysis of the particle size distribution (PSD) of granules was performed to understand the phenomena involved during the granulation process and to optimize the operating conditions. Hydroxypropyl methylcellulose (HPMC) granules were produced spraying distilled water as liquid binder on powders in a low-shear granulator. The experimental campaign was planned using the full factorial design statistical technique varying two factors (impeller rotation speed and binder flow rate), each at three intensities. PSDs of HPMC granules at different granulation times were obtained by an ad hoc dynamic image analysis device based on the free falling particle scheme. PSD measurements showed that wet granules size depends on the simultaneous presence of nucleation, agglomeration and breakage phenomena. The process parameters optimization was carried out using response surface methodology (RSM) and using the granulation yield (% w/w of wet granules within the size range 2000\textendash10,000 μm) as the main variable of interest.},

keywords = {Granulation, HPMC},

pubstate = {published},

tppubtype = {article}

}

@article{{DeSimone}2018,

title = {HPMC granules by wet granulation process: Effect of vitamin load on physicochemical, mechanical and release properties},

author = {Veronica {De Simone} and Annalisa Dalmoro and Gaetano Lamberti and Diego Caccavo and Matteo D'Amore and Anna Angela Barba },

url = {http://www.sciencedirect.com/science/article/pii/S0144861717313425},

doi = {10.1016/j.carbpol.2017.11.056},

year  = {2018},

date = {2018-02-01},

journal = {Carbohydrate Polymers},

volume = {181},

pages = {939-947},

abstract = {Due to its versatile properties, hydroxypropyl methylcellulose (HPMC) is largely used in many applications and deeply studied in the various  elds such as pharmaceuticals, biomaterials, agriculture, food, water puri cation. In this work, vitamin B12 loaded HPMC granules were produced to investigate their potential application as nutraceutical products. To this aim the impact of vitamin load on physico-chemical, mechanical and release properties of granules, achieved by wet granulation process, was investigated. In particular, three different loads of B12 (1%, 2.3% and 5% w/w) were assayed. Unloaded granules (used as control) and loaded granules were dried, sieved, and then the suitable fraction for practical uses, 0.45\textendash2 mm in size, was fully characterized. Re- sults showed that the vitamin incorporation of 5% reduced the granulation performance in the range size of 0.45\textendash2 mm and led granules with higher porosity, more rigid and less elastic structures compared to unloaded granules and those loaded at 1% and 2.3% of B12. Vitamin release kinetics of fresh and aged granules were roughly found the same trends for all the prepared lots; however, the vitamin B12 was released more slowly when added with a load at 1% w/w, suggesting a better incorporation.},

keywords = {Granulation},

pubstate = {published},

tppubtype = {article}

}

@article{Caccavo2017b,

title = {HPMC-Based Granules for Prolonged Release of Phytostrengtheners in Agriculture},

author = {Diego Caccavo and Sara Cascone and Pietro Apicella and Gaetano Lamberti and Anna Angela Barba},

url = {http://www.tandfonline.com/doi/full/10.1080/00986445.2017.1362398},

doi = {10.1080/00986445.2017.1362398 },

issn = {0098-6445},

year  = {2017},

date = {2017-12-01},

journal = {Chemical Engineering Communications},

volume = {204},

number = {12},

pages = {1333-1340},

abstract = {One of the main aim in agriculture is to guarantee soil wellness, which is a fundamental requirement to produce high quality crops with high yields. Focused on this aim, periodical administrations of nutrients or phytostrengtheners are often necessary. The most relevant disadvantages of these administrations are the high dosage number required and the low availability of the substance within the soil. For these reasons, a crucial goal to increase the economic and environmental sustainability of the cultivation process is to reduce the dosage number, which can be obtained increasing the active substance availability in the soil. A granular HPMC (HydroxyPropyl MethylCellulose) matrix, produced using the wet granulation process, was used to encapsulate a phytostrengthener and to guarantee its controlled release. The granular product was characterized in terms of granules properties and phytostrengtheners leaching within the soil. The results showed good flowability and mechanical properties of the granules as well as the possibility to reduce the product leaching with the phytostrengtheners encapsulation in the HPMC matrices.},

keywords = {Granulation, HPMC},

pubstate = {published},

tppubtype = {article}

}

@article{Caccavo2015,

title = {Hydrogel-based Granular Phytostrengtheners for Prolonged Release: Production and Characterization},

author = { Diego Caccavo and Sara Cascone and Maria Chiara Amoroso and Pietro Apicella and Gaetano Lamberti and Anna Angela Barba},

url = {http://www.aidic.it/cet/15/44/040.pdf},

doi = {10.3303/CET1544040},

year  = {2015},

date = {2015-01-01},

journal = {Chemical Engineering Transaction},

volume = {44},

pages = {235--240},

abstract = {Soil wellness is an indispensable requirement to obtain fruits and vegetables with finest quality and with high yields. To the purpose, periodical administrations of nutrients, as well as phytostrengtheners could be required. Crucial goals to maximize the economic and environmental sustainability of the whole cultivation are the decrease of the dosages number together with the increase of the active substance availability within the soil. With these aims a controlled release phytostrengtheners encapsulated in a granular Hydroxypropyl methylcellulose matrix has been developed exploiting the wet granulation process. The granular product has been analyzed in terms of Particle Size Distribution (PSD), morphology and flowability. The results showed the effectiveness of the granulation process and the good flowability of the granules, highly desirable features for the product handling and commercialization.},

keywords = {Granulation, Hydrogel Characterization, Tecnagri},

pubstate = {published},

tppubtype = {article}

}

@article{Caccavo2011,

title = {Criteri per progettare e gestire il processo di granulazione},

author = { Diego Caccavo and Sara Cascone and Gaetano Lamberti},

year  = {2011},

date = {2011-01-01},

journal = {ICP Rivista dell'Industria Chimica},

volume = {4},

pages = {74--78},

abstract = {Un approccio ingegneristico, basato su poche misure e ripetibili, e coaudiuvato dalla modellazione fisico-matematica, pu\`{o} essere di grande aiuto nella gestione del processo di granulazione.},

keywords = {Granulation},

pubstate = {published},

tppubtype = {article}

}